Sunday, January 12, 2014

Tutorial: Small Envelope Gift Card Holder

Hi Stampers!

This is a really quick and easy little project using the Envelope Punch Board & a few scraps of cardstock & DSP.  It'll literally only take you a few minutes to put together.


Using your EPB, make an envelope for card size 2 1/2" x 3 1/2" - it's the third one down on the left hand side.

Next, take a scrap of cardstock and cut it to 4 1/4" x 2 1/2", and again using your EPB, punch a tab at the 1" mark then flip it and punch again at the 1" mark.  This makes the "file tab" you see on the red piece of cardstock above.

For the envelope liner, I hand cut a triangle and left a bit of a rectangular tail on the end and used the rounder on the EPB to round the tip.

Then I added a stamped image and a few embellishments.  The gift card is attached to the tabbed red piece with a glue dot.  Easy peasy!

You could even put this on a card front if you want to be able to seal it up inside an envelope.

Happy stampin'!

post signature

No comments :

Post a Comment

Thanks for visiting & commenting!